This page is relevant for the LaCie NAS 2Big Network v2. It is the direct successor of the 2big Network (orion-based).

• CPU ARM926EJ-S (ARMv5TE) 1200MHz
• SoC Kirkwood 88F6281_A0
• SDRAM memory 256MB, DDR2 400MHz
• SPI flash, NOR 512KB (MACRONIX MX25L4005CMI-12G)
• Ethernet Gigabit port (PHY MARVELL 88E1116R)
• 1 USB2 port, 1 connector host and 1 connector device
• 2 SATA port and 1 SATA port multiplier x2 (JMicron JMB350 revA or revB)
• 2 SATA and 1 eSATA connectors
• I2C EEPROM, 512 bytes (24C04 type)
• 1 bi-color (blue and red) front LED
• 2 bi-color (blue and red) disk LEDs with CPLD SATA activity blink
• Front push button
• Rear power switch
• Serial: undocumented TTL serial interface (3.3V)

An unreliable configuration is available here

U-Boot mainline support is done.

The boards are almost fully supported mainline. For more informations, see our Linux for Kirkwood page.

It is also possible to install Debian, look here.

For more informations about the LaCie stock system, look here.