This is an old revision of the document!
LaCie Network Space v2
This page is relevant for Network Space (Max) v2 and Internet Space v2 boards.
Hardware
CPU ARM926EJ-S (ARMv5TE) 800MHz
SoC Kirkwood 88F6281_A0
SDRAM memory 256MB, DDR2 533MHz
SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G)
Ethernet Gigabit port (PHY MARVELL 88E1116R)
1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2)
1 SATA port (2 ports for Network Space Max v2)
I2C EEPROM, 512 bytes (24C04 type)
2 LEDs (blue and red with CPLD SATA activity blink)
Power push button
Openocd
An unreliable configuration is available here
U-Boot
The boards are almost fully supported mainline. For more informations, see our U-Boot main page
Here are the remaining tasks:
Initialize MAC address from I2C EEPROM.
Merge patch “sf: macronix: disable write protection when initializing” with mainline.
Configure GPIO LEDs.
Enhance the default boot sequence (environment variables).
Linux
The boards are almost fully supported mainline.
Userspace