This page is relevant for Network Space (Max) v2 and Internet Space v2 boards.

• CPU ARM926EJ-S (ARMv5TE) 800MHz
• SoC Kirkwood 88F6281_A0
• SDRAM memory 256MB, DDR2 533MHz
• SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G)
• Ethernet Gigabit port (PHY MARVELL 88E1116R)
• 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2)
• 1 SATA port (2 ports for Network Space Max v2)
• I2C EEPROM, 512 bytes (24C04 type)
• 2 LEDs (blue and red with CPLD SATA activity blink)
• Power push button

An unreliable configuration is available here

The boards are almost fully supported mainline. For more informations, see our U-Boot for Kirkwood page.

The boards are almost fully supported mainline. For more informations, see our Linux for Kirkwood page.

Normally, after applying power, you have to push the button to turn on the ns2. If you want it to switch on automatically, you have to switch a bit in the i2c eeprom. The bit is at offset 14 in the eeprom, changing it from 0 to 1 will enable auto switch on. For more details see eeprom_organization