This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
network_space_v2 [2011/09/20 16:44] – Auto power on 92.54.8.30 | network_space_v2 [2012/09/08 16:16] (current) – minor change 82.234.233.9 | ||
---|---|---|---|
Line 2: | Line 2: | ||
This page is relevant for Network Space (Max) v2 and Internet Space v2 boards. | This page is relevant for Network Space (Max) v2 and Internet Space v2 boards. | ||
+ | |||
+ | Since mid-2011 lacie change the hardware configuration of the network space v2 to a lower one, see [[network_space_lite_v2|LaCie Network Space Lite v2]]. | ||
===== Hardware ===== | ===== Hardware ===== | ||
Line 7: | Line 9: | ||
* CPU ARM926EJ-S (ARMv5TE) 800MHz | * CPU ARM926EJ-S (ARMv5TE) 800MHz | ||
* SoC Kirkwood 88F6281_A0 | * SoC Kirkwood 88F6281_A0 | ||
- | * SDRAM memory 256MB, DDR2 533MHz | + | * SDRAM memory 256MB, DDR2 267MHz |
- | * SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G) | + | * SPI flash, NOR 512kB (MACRONIX MX25L4005CMI-12G) |
* Ethernet Gigabit port (PHY MARVELL 88E1116R) | * Ethernet Gigabit port (PHY MARVELL 88E1116R) | ||
* 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2) | * 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2) | ||
Line 33: | Line 35: | ||
===== Userspace ===== | ===== Userspace ===== | ||
- | ===== Auto power on ===== | + | It is also possible |
- | + | ||
- | Normally, after applying power, you have to push the button to turn on the ns2. If you want it to switch on automatically, you have to switch a bit in the i2c eeprom. | + | |
- | The eeprom is available for reading and writing under Linux at the pseudo file **/ | + | |
- | The content of the eeprom is the following: | + | |
- | ^Offset ^Meaning | + | ===== LaCie system ===== |
- | |00..01 |Version/ | + | |
- | |02..07 |Mac address | + | |
- | |08..13 |2nd Mac address | + | |
- | |14 | + | |
- | |15 |Fake sleepmode | + | |
- | Changing byte 14 from 0 to 1 will enable auto switch on. | + | For more informations about the LaCie stock system, look [[lacie_stock|here]]. |