The 2big Network v2 is a Linux-based NAS with a Marvell Board. It is the direct successor of the 2big Network (orion-based).

• Board: 88F6281 A0 LE
• Cpu: ARM926EJ-S [56251311] revision 1 (ARMv5TE), cr=00053177
• RAM: 256 Mb DDR2
• Network: 1×10/100/1000 Marvell Gigabit ethernet
• USB: 2×2.0 ports, 1 host (to connect a mass storage device, an ups or a printer) and 1 gadget (to use the 2big as an usb hard drive)
• eSata: 1 port
• Storage: 2×1000/1500/2000 Gb Seagate SATA disks
• LEDs: Frontal blue/red led, disk activity/functional led
• Flash: TODO
• Serial: undocumented TTL serial interface (3.3V)

• Bootloader: TODO
• Boot method: U-Boot image on disk
• Kernel commandline: console=ttyS0,115200 root=/dev/sda7 ro reset=0 productType=PRO_KW

• Kernel: Linux 2.6.22.18
• Coreutils: busybox
• HTTP: lighttpd
• FTP: ProFTPd
• SMB: Samba (unix extensions disabled by default; to enable them, change the corresponding line in /snaps/00/etc/samba/smb.conf on sda9)
• Bonjour: Avahi/Zeroconf
• SSH: Openssh (disabled by default; to enable it, uncomment the corresponding line in /etc/initng/runlevel/default.runlevel on sda8 and change root password in /etc/shadow on sda9)
• Rsync: disabled by default, to enable it define a new daemon in /etc/initng on sda9 to launch “/usr/bin/rsync –daemon” and add it to /etc/initng/runlevel/default.runlevel

• sda1: extended, 2056 Mb
• sda2: xfs, md raid0/raid1, user data, the remaining part of the disk
• sda5: swap, md raid1, 263,18 Mb
• sda6: Linux kernel U-Boot Image, 8,23 Mb
• sda7: ext3, md raid1, minimal root partition, 8,23 Mb
• sda8: ext3, md raid1, original firmware partition, 871,88 Mb
• sda9: ext3, md raid1, snapshots/upgrades partition, 896,56 Mb
• sda10: filled with zeroes (may be used for an alternate kernel), 8,23 Mb

Mainline support is currently being worked on.

This board works well with clunc; main LED will become red while clunc is active.