This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
network_space_v2 [2011/07/15 22:25] – simon | network_space_v2 [2012/09/08 16:16] (current) – minor change 82.234.233.9 | ||
---|---|---|---|
Line 2: | Line 2: | ||
This page is relevant for Network Space (Max) v2 and Internet Space v2 boards. | This page is relevant for Network Space (Max) v2 and Internet Space v2 boards. | ||
+ | |||
+ | Since mid-2011 lacie change the hardware configuration of the network space v2 to a lower one, see [[network_space_lite_v2|LaCie Network Space Lite v2]]. | ||
===== Hardware ===== | ===== Hardware ===== | ||
Line 7: | Line 9: | ||
* CPU ARM926EJ-S (ARMv5TE) 800MHz | * CPU ARM926EJ-S (ARMv5TE) 800MHz | ||
* SoC Kirkwood 88F6281_A0 | * SoC Kirkwood 88F6281_A0 | ||
- | * SDRAM memory 256MB, DDR2 533MHz | + | * SDRAM memory 256MB, DDR2 267MHz |
- | * SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G) | + | * SPI flash, NOR 512kB (MACRONIX MX25L4005CMI-12G) |
* Ethernet Gigabit port (PHY MARVELL 88E1116R) | * Ethernet Gigabit port (PHY MARVELL 88E1116R) | ||
* 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2) | * 1 USB2 port, 1 connector host and 1 connector device (except for Internet Space v2) | ||
Line 25: | Line 27: | ||
===== U-Boot ===== | ===== U-Boot ===== | ||
- | The boards are almost fully supported mainline. For more informations, | + | The boards are almost fully supported mainline. For more informations, |
- | Here are the remaining tasks: | + | ===== Linux ===== |
- | * Initialize MAC address from I2C EEPROM. | + | The boards are almost fully supported |
- | * Merge patch "sf: macronix: disable write protection when initializing" | + | |
- | * Configure GPIO LEDs. | + | |
- | * Enhance the default boot sequence (environment variables). | + | |
- | ===== Linux ===== | + | ===== Userspace |
- | The boards are almost fully supported mainline. | + | It is also possible to install Debian, look [[debian_install|here]]. |
- | Here are the remaining tasks: | + | ===== LaCie system ===== |
- | * USB device support: host/device switch and GPIOs configuration. | + | For more informations about the LaCie stock system, look [[lacie_stock|here]]. |
- | * Hard disk GPIOs support. | + | |
- | ===== Userspace ===== |