This page is relevant for Internet Space v1. This device can be found rebranded by Orange as “HomeLibrary”.

• CPU ARM926EJ-Sid(wb) rev 0 (v5l) 400MHz (266 bogoMIPS)
• SoC Orion 88F5182-A2 C400 (Marvell)
• SDRAM memory 64MB, (Hynix DDR2 HY5PS561621B FP-25)
• SPI flash, NOR 512kB (MACRONIX MX25L4005CTTC-55Q)
• Ethernet Gigabit port (PHY MARVELL 88E1118R-NNG2)
• 1 USB2 port (host connector)
• 1 SATA port
• 1 blue LED
• Power push button
• Power (12V)

Marvell>> imd  0x50 0 8
0000: 00 d0 4b 85 f6 98 00 ff    ..K.....
Marvell>> 

U-Boot don't support the device although the internet space v1 is very similar than edminiv2.

Marvell>> printenv
bootargs=console=ttyS0,115200 root=/dev/sda7 ro
bootcmd=if lump 2; then ; else run disk_disk; fi
baudrate=115200
loads_echo=0
kernel_addr=0x400000
boot_disk=disk ${kernel_addr} 1:6
snap_disk=if snapboot 1:9 ${kernel_addr}; then; else run boot_disk; fi
disk_disk=ide reset; run snap_disk; bootm ${kernel_addr};
ethaddr=00:d0:4b:85:f6:98
stdin=serial
stdout=serial
stderr=serial
cpuName=926
CASset=min
enaMonExt=no
enaFlashBuf=yes
enaCpuStream=no
MALLOC_len=4
ethprime=egiga0
bootdelay=3
disaMvPnp=no
overEthAddr=no
usb0Mode=host
usb1Mode=device
ethact=egiga0
 
Environment size: 558/40956 bytes
Marvell>>

Linux don't have support for the device, but patched edminiv2 v3.6 kernel works.

Debian kernel don't support the device, but the distribution works.

• Building uImage and debian linux kernel package for internet space v1
• Preparing a debian disk installation using stock lacie U-Boot