====== Lacie 2big Network v2 ======

This page is relevant for the LaCie NAS 2Big Network v2. It is the direct successor of the [[2big_network|2big Network]] (orion-based).

===== Hardware =====

  * CPU ARM926EJ-S (ARMv5TE) 1200MHz
  * SoC Kirkwood 88F6281_A0
  * SDRAM memory 256MB, DDR2 400MHz
  * SPI flash, NOR 512KB (MACRONIX MX25L4005CMI-12G)
  * Ethernet Gigabit port (PHY MARVELL 88E1116R)
  * 1 USB2 port, 1 connector host and 1 connector device
  * 2 SATA port and 1 SATA port multiplier x2 (JMicron JMB350 revA or revB)
  * 2 SATA and 1 eSATA connectors
  * I2C EEPROM, 512 bytes (24C04 type)
  * 1 bi-color (blue and red) front LED
  * 2 bi-color (blue and red) disk LEDs with CPLD SATA activity blink
  * Front push button
  * Rear power switch
  * Serial: undocumented TTL serial interface (3.3V)

{{:net2big_v2_00.jpg?640x480|2Big Network v2}}
{{:net2big_v2_01.jpg?640x480|2Big Network v2}}

===== OpenOCD =====

An unreliable configuration is available [[ftp://lacie-nas.org/openocd/net2big_v2.cfg|here]]

===== U-Boot =====

U-Boot mainline support is done.

===== Linux =====

The boards are almost fully supported mainline. For more informations, see our [[linuxforkirkwoodsocs|Linux for Kirkwood]] page.

===== Userspace =====

It is also possible to install Debian, look [[debian_install|here]].

===== LaCie System =====

For more informations about the LaCie stock system, look [[lacie_stock|here]].