User Tools

Site Tools


network_space_lite_v2

This is an old revision of the document!


LaCie Network Space Lite v2

Since mid-2011 lacie change the hardware configuration of the network space v2 to a lower one.

Hardware

  • CPU: Marvell 88F6192 800Mhz
  • SDRAM memory: 128 MiB DDR2
  • Gigabit ethernet: PHY Marvell 88E1318
  • Flash memory: Macronix MX25L4005A 512 KiB
  • i2c EEPROM: 512 bytes
  • 2 USB2 ports: host and host/device
  • 1 push button
  • 2 LEDs (red and blue)
% cat /proc/cpuinfo
Processor	: Feroceon 88FR131 rev 1 (v5l)
BogoMIPS	: 795.44
Features	: swp half thumb fastmult edsp 
CPU implementer	: 0x56
CPU architecture: 5TE
CPU variant	: 0x2
CPU part	: 0x131
CPU revision	: 1
Hardware	: LaCie Network Space Lite v2
Revision	: 0001
Serial		: 0000000000000000
% cat /proc/meminfo
MemTotal:         124252 kB

Linux Kernel

The support of this configuration is not yet mainline in the linux kernel. A patch from cvubrugier is under validation to be put mainline in the linux kernel. You can find it here

Custom System Install

Patition Table

Current partition table

/dev/sda5	SWAP
/dev/sda6	RAW Kernel
/dev/sda7	ext3 		/
/dev/sda8	ext3
/dev/sda9	ext3 in unionfs
/dev/sda10	RAW Kernel 

Build your new partition table

The hard disk can be entirelly wipe. But if you want to be able to boot your new system without have to flash uboot you need to respect the position of the kernel and the root filesystem.

The kernel have to be on the /dev/sda6
The root filsystem have to be on the /dev/sda7

Install your custom kernel

To install your custom build kernel do a raw paste on /dev/sda6

#dd if=uImage of=/dev/sda6
network_space_lite_v2.1321534821.txt.gz · Last modified: 2011/11/17 14:00 by 193.56.60.160