LaCie NAS wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== LaCie Network Space Lite v2 ======

Since mid-2011 lacie change the hardware configuration of the network space v2 to a lower one.

===== Hardware =====

  * CPU: Marvell 88F6192 800Mhz
  * SDRAM memory: 128 MiB DDR2
  * Gigabit ethernet: PHY Marvell 88E1318
  * Flash memory: Macronix MX25L4005A 512 KiB
  * i2c EEPROM: 512 bytes
  * 2 USB2 ports: host and host/device
  * 1 push button
  * 2 LEDs (red and blue)

	% cat /proc/cpuinfo
	Processor	: Feroceon 88FR131 rev 1 (v5l)
	BogoMIPS	: 795.44
	Features	: swp half thumb fastmult edsp 
	CPU implementer	: 0x56
	CPU architecture: 5TE
	CPU variant	: 0x2
	CPU part	: 0x131
	CPU revision	: 1
	Hardware	: LaCie Network Space Lite v2
	Revision	: 0001
	Serial		: 0000000000000000

	% cat /proc/meminfo
	MemTotal:         124252 kB
 
====== Pictures ======

Front:

{{http://www.starox.org/pub/Network_Space_V2_Lite/Network_Space_V2_Lite-front.jpg?900}}

Back:

{{http://www.starox.org/pub/Network_Space_V2_Lite/Network_Space_V2_Lite-back_2.jpg?900}}

===== Linux Kernel =====

The support of this configuration is not yet mainline in the linux kernel.
A patch from **cvubrugier** is under validation to be put mainline in the linux kernel. You can find it [[http://permalink.gmane.org/gmane.linux.ports.arm.kernel/140395|here]]

	

===== Custom System Install =====

==== Patition Table ====

=== Current partition table ===

	/dev/sda5	XFS             data
	/dev/sda5	SWAP
	/dev/sda6	RAW Kernel
	/dev/sda7	ext3 		/
	/dev/sda8	ext3
	/dev/sda9	ext3 in unionfs
	/dev/sda10	RAW Kernel 

=== Build your new partition table ===

The hard disk can be entirelly wipe. But if you want to be able to boot your new system without have to flash uboot you need to respect the position of the kernel and the root filesystem. 

	The kernel have to be on the /dev/sda6
	The root filsystem have to be on the /dev/sda7

=== Install your custom kernel ===

To install your custom build kernel do a raw paste on /dev/sda6

	#dd if=uImage of=/dev/sda6

==== The system ====

To install your system you can follow instruction for [[debian_install|Debian]] or [[installarchlinux|ArchLinux]] or even build your own system with [[http://buildroot.uclibc.org|buildroot]].
LaCie NAS wiki

User Tools

Site Tools

Page Tools
