LaCie NAS wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Lacie 2big Network======
The 2big Network is a Linux-based NAS with a Marvell Board.
===== Hardware =====
  * Board: MV-88fxx81
  * Cpu: Marvell Orion ARM926EJ 400 Mhz
  * RAM: 64 Mb DDR2
  * Network: 1x10/100/1000 Marvell Gigabit ethernet
  * USB: 2x2.0 ports
  * Storage: 2x500/1000 Gb SATA disks
  * LEDs: Frontal blue/red led, disk activity/functional led
  * Flash: 512 Kb MX29LV400CBTC-70G
  * Serial: undocumented TTL serial interface (3.3V)
===== System =====
==== Boot ====
  * Bootloader: U-Boot 1.1.1 (Jun 15 2007 - 08:56:23) Marvell version: 1.7.3 - LaCie version: 1.4.alpha_3
  * Boot method: U-Boot image on disk
  * Kernel commandline: console=ttyS0,115200 root=/dev/sda7 ro reset=0
==== Operating system ====
  * Kernel: linux-2.6.12.6-arm1-lacie5e
  * Coreutils: busybox
  * FTP: ProFTPd
  * SMB: Samba
  * Bonjour: Avahi/Zeroconf
==== Partitions ====
  * sda1: extended, 980 Mb
  * sda2: xfs, md linear/raid1, user data, the remaining part of the disk
  * sda5: swap, md raid1, 130 Mb
  * sda6: Linux kernel U-Boot Image, 8 Mb
  * sda7: ext3, md raid1, minimal root partition, 8 Mb
  * sda8: ext3, md raid1, original firmware partition, 130 Mb
  * sda9: ext3, md raid1, snapshots/upgrades partition, 696 Mb
  * sda10: filled with zeroes (may be used for an alternate kernel), 8 Mb
===== Mainline linux support =====
Mainline support was added in linux 2.6.32 and the default config file for Orion boards works. However, this board by default has a wrong arcNumber (526), that prevents a normal kernel from booting. A solution is to edit "mach-types" in the kernel source tree and change 2big network number to 526. Apart from that, there is full support for every hardware component, including LEDs.

===== Clunc support =====
This board works well with clunc; main LED will become red while clunc is active.
LaCie NAS wiki

User Tools

Site Tools

Page Tools
