2big_network_v2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 2big_network_v2 [2011/11/01 15:20] – 82.234.233.9 | 2big_network_v2 [2013/07/07 17:04] (current) – fix typo in flash size starox | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| * SoC Kirkwood 88F6281_A0 | * SoC Kirkwood 88F6281_A0 | ||
| * SDRAM memory 256MB, DDR2 400MHz | * SDRAM memory 256MB, DDR2 400MHz | ||
| - | * SPI flash, NOR 512MB (MACRONIX MX25L4005CMI-12G) | + | * SPI flash, NOR 512KB (MACRONIX MX25L4005CMI-12G) |
| * Ethernet Gigabit port (PHY MARVELL 88E1116R) | * Ethernet Gigabit port (PHY MARVELL 88E1116R) | ||
| * 1 USB2 port, 1 connector host and 1 connector device | * 1 USB2 port, 1 connector host and 1 connector device | ||
| Line 19: | Line 19: | ||
| * Rear power switch | * Rear power switch | ||
| * Serial: undocumented TTL serial interface (3.3V) | * Serial: undocumented TTL serial interface (3.3V) | ||
| + | |||
| + | {{: | ||
| + | {{: | ||
| ===== OpenOCD ===== | ===== OpenOCD ===== | ||
| Line 26: | Line 29: | ||
| ===== U-Boot ===== | ===== U-Boot ===== | ||
| - | U-Boot mainline support is ongoing. For more informations, | + | U-Boot mainline support is done. |
| ===== Linux ===== | ===== Linux ===== | ||
| Line 33: | Line 36: | ||
| ===== Userspace ===== | ===== Userspace ===== | ||
| + | |||
| + | It is also possible to install Debian, look [[debian_install|here]]. | ||
| ===== LaCie System ===== | ===== LaCie System ===== | ||
| - | This section describes | + | For more informations about the LaCie stock system, |
| - | + | ||
| - | ==== Boot ==== | + | |
| - | + | ||
| - | * Bootloader: TODO | + | |
| - | * Boot method: U-Boot image on disk | + | |
| - | * Kernel commandline: | + | |
| - | + | ||
| - | ==== Operating system ==== | + | |
| - | + | ||
| - | * Kernel: Linux 2.6.22.18 | + | |
| - | * Coreutils: busybox | + | |
| - | * HTTP: lighttpd | + | |
| - | * FTP: ProFTPd | + | |
| - | * SMB: Samba (unix extensions disabled by default; to enable them, change the corresponding line in / | + | |
| - | * Bonjour: Avahi/ | + | |
| - | * SSH: Openssh (disabled by default; to enable it, uncomment the corresponding line in / | + | |
| - | * Rsync: disabled by default, to enable it define a new daemon in /etc/initng on sda9 to launch "/ | + | |
| - | * Deep sleep mode: can be enabled from the web interface, but if ssh has been enabled it is simpler to call / | + | |
| - | + | ||
| - | ==== Partitions ==== | + | |
| - | + | ||
| - | * sda1: extended, 2056 Mb | + | |
| - | * sda2: xfs, md raid0/ | + | |
| - | * sda5: swap, md raid1, 263,18 Mb | + | |
| - | * sda6: Linux kernel U-Boot Image, 8,23 Mb | + | |
| - | * sda7: ext3, md raid1, minimal root partition, 8,23 Mb | + | |
| - | * sda8: ext3, md raid1, original firmware partition, 871,88 Mb | + | |
| - | * sda9: ext3, md raid1, snapshots/ | + | |
| - | * sda10: filled with zeroes (may be used for an alternate kernel), 8,23 Mb | + | |
2big_network_v2.1320157202.txt.gz · Last modified: by 82.234.233.9
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
